Shopping cart 0
Standard

IEEE 63004-2015

Published

Note: This standard has a new edition: IEEE 63004-2015

Preview

Corrigendums and amendments are bought separately.

Language
Services

Abstract

Adoption Standard - Active. A mechanical and electrical specification for implementing a common interoperable mechanical quick-disconnect interconnect system for use by industry for interfacing large numbers of electrical signals (digital, analog, RF, power, etc.) is provided. These large interface panels (receiver and fixture panels) are employed primarily in test systems between stimulus/measurement assets and a related unit-under-test (UUT), although any application involving high-density contacts requiring a quick disconnect interface could benefit. The receiver is a receptacle that is mounted to test system mates with multiple fixtures, which serve as the buffer between the UUT and automatic test equipment (ATE). Fixtures translate standard input/output (I/O) signal routing offered at the receiver to a wiring interface that directly connects to the UUT. These UUT interfaces can represent cable connectors, direct plug-in (printed circuit board edge connectors), sensor monitoring, or manual feedback from the test technician. The primary objectives of this standard are: (a) to establish interface standards that permit interchangeability of mechanical/electrical receiver/fixture/connector product assemblies from various manufacturers under an open architecture; and (b) to develop within this framework a defined set(s) of interconnecting connector and mechanical specifications that supports available, accepted, low-cost commercial technology to reduced dependence on proprietary designs and extend life-cycle availability.

Document information

  • Standard from IEEE/IEC
  • Published:
  • Document type: IS
  • Pages
  • Publisher IEEE/IEC
  • Distributor IEEE/IEC
  • ICS 31.220.10
  • Technical Committee IEEE SA Board of Governors / SCC20 - Test and Diagnosis for Electronic Systems

Product Relations

  • Refers: ASTM A582M-05, Standard Specification for Free-Machining Stainless Steel Bars.
  • Refers: ASTM A342, Standard Test Methods for Permeability of Feebly Magnetic Materials; equivalent to MIL-I-17214.
  • Refers: ASTM A581, Standard Specification for Free-Machining Stainless Steel Wire and Wire Rods.
  • Refers: ASTM A484M-03, Standard Specification for General Requirements for Stainless Steel Bars, Billets, and Forgings.
  • Refers: ASTM A240, Standard Specification for Chromium and Chromium-Nickel Stainless Steel Plate, Sheet, and Strip for Pressure Vessels and for General Applications; equivalent to SAE-AMS-QQ-S-766.
  • Refers: ASTM A666-00, Standard Specification for Annealed or Cold-Worked Austenitic Stainless Steel Sheet, Strip, Plate, and Flat Bar.
  • Refers: ASTM A693-06, Standard Specification for Precipitation-Hardening Stainless and Heat-Resisting Steel Plate, Sheet, and Strip.